Two versions of Ms

Fountain Pen Troubleshooting


New Nib (top) and Nib with Coating Removed (bottom)Dip pens could be only a little challenging for beginners or for those going from a calligraphy fountain pen or calligraphy marker. Perhaps one of the most common problems gets the ink to flow regularly from the nib – either maybe not streaming adequate (scratchy or skipping) or streaming too quickly (blotting).

These are just some troubleshooting tips whenever having troubles with dip pens – certainly not a comprehensive list, but a few typical problems that are really easy to solve.

Pen Nibs

New Nibs

A brand new nib will have a finish on it which will must be removed as it will interfere with ink flow. The finish is done at production degree to help keep the metal nibs from rusting (you wouldn’t are interested to buy a rusty nib!)

There are lots of approaches to repeat this – some more complex than others – but generally speaking a scrubbing with a classic, smooth toothbrush and a bit of meal washing fluid, baking soft drink, tooth paste or ammonia will do the secret.

Once the picture indicates, the utmost effective nib seems a bit shinier using layer and duller using the coating removed (base nib.) After the finish is removed the nib is vunerable to rust, therefore it is important to clean and thoroughly dried out the nibs after use.

Wrecked Nibs

Pen Cleaner, Sharpening rock and Old brushexamine the nib to guarantee the tines aren't curved or overlapping. This can occur with nibs being slim (tiny nibs sizes) and versatile. If bending or overlapping just isn't too serious, the tines can often be pressed gently back into location. In the event that tines tend to be severely curved it may be time and energy to replace the nib.

Eventually, nibs might wear out and won’t produce crisp, clean pen strokes. Sometimes they is carefully sharpened utilizing an Arkansas (white) sharpening stone – you should be certain that the nib isn’t so razor-sharp that it cuts the paper!

Rusty Nibs

I'ven’t found something that will “cure” corrosion on a nib aside from just changing the nib. Hans Presto implies a fibreglass brush for the removal of dried paint, and since they truly are always remove rust on vehicles it might be worth an attempt if you should be determined to truly save that nib and also the corrosion isn’t too extreme.

A few useful “pen nib attention” tools that may be beneficial in your calligraphy work space or art package – pen cleanser, sharpening stone and a classic tooth-brush.

An even more pricey substitute for cleaning pen nibs is a small ultrasonic cleanser with a pen cleansing solution. They're going to do a fantastic job of cleaning various types of pen nibs, technical pencils etc. and might be really worth the investment for professionals who do a top amount of work.

Nibs and ReservoirsReservoirs

The reservoir is what holds the ink and feeds it towards the nib. Pen nibs typically also come in two varieties, a reservoir connected to the top (Brause, Tape, TO, Speedball, etc.) or connected to the base (Mitchell). The reservoirs are held on the nib with metal prongs that will keep carefully the reservoir firmly mounted on nib without sliding or falling-off.

In the event that reservoir can be eliminated (many nibs except the Speedball nibs) then disassemble the nib and cleanse the reservoir. Ink can establish and cause the ink to move unevenly or may also combine dried ink bits to the ink.

Some companies have actually a shaped “lip” built into the nib (or what might be known as a “reservoir signal), and I have discovered this is usually the best place for reservoir. When connecting the reservoir right back onto the nib, make sure the reservoir is equipped back to this position utilizing the top of the reservoir prongs around the prolonged “lip”.

The reservoir tip should you need to be touching the nib and centered, maybe not level against it or forced aside. If this 's stilln’t working well, take to moving the reservoir down slightly underneath the lip.

If you're having troubles obtaining the ink to move because of the reservoir, try removing it and loading the back of the nib with a bit of ink and attempt various pen shots. When you are able produce a couple of decent shots (adjusting hand pressure, various type nib or ink, etc.) re-attach the reservoir and try again.

Reservoir Indicator on Brause Nib Reservoir Position on Brause Nib Reservoir on Mitchell Nib Two samples of Pen Holders


Share this article





Related Posts


Fountain pens. best
Fountain pens. best
Fountain pen nibs sizes
Fountain pen nibs sizes

Latest Posts
Waterman Pens history
Waterman Pens…
Savvy enthusiasts have actually known…
Lamy Palladium
Lamy Palladium
A Collective Review of the Lamy Dialog…
Lamy Studio Black Fountain Pen
Lamy Studio Black…
This is actually the Lamy Studio Fountain…
Waterman Serenite Fountain Pen
Waterman Serenite…
When I look at the reputation for the…
Pilot G 2 Pro
Pilot G 2 Pro
It is a hectic few days which means this…
Search
Featured posts
  • Fountain pens. best
  • Fountain pen nibs sizes
  • Fountain Pen Converters
  • Fountain Pen converter VS cartridge
  • Muji Fountain Pen converter
  • Cross Fountain Pen Repair
  • Fountain Pens Parker 51
  • Parker Fountain Pen repair
  • Mont Blanc Fountain Pen
Copyright © 2017 l www.fountainpenbiz.com. All rights reserved.